Our high pressure hose 600-840 bar
is suitable for all grease lubrication systems
of regular manufacturers. You can obtain further information on our grease and lubrication hose if you click on one of the pictures of the high pressure hose.
The high pressure hose 600-840 bar is extremely resistant to pressure and has however a very highly flexibility.
The design of this high pressure hose 600-840 bar consists of an inner tube of polyamide 6 (PA6) coated with a polyester mesh and glued. The polyurethane outer skin of the high pressure hose 600-840 bar is also glued to the polyester mesh and the inner tube (unfortunately, not all manufacturer of high pressure hoses 600-840 bar ensure the same), which guarantees the high pressure resistance.
Only with a sufficiently good gluing of the inner tube, polyester mesh and outer skin, the high pressure hose 600-840 bar is both pressure-resistant and installation-secure with our screw sleeve and hose studs.
All leading manufacturers in the sectors of central lubrication installations, central lubrication systems and central lubrication technology rely on this high pressure hose 600-840 bar, therefore we also trust and deliver this high-quality high pressure hose 600-840 bar
It is available in two sizes, DN 4 and DN 6 (i.e. different inner and outer diameter).
We deliver our high pressure hose 600-840 bar pre-filled but also unfilled (i.e. empty). The later gives the user the opportunity to fill this high pressure hose 600-840 bar with a special lubricant, e.g. for the food industry.
Our high pressure hose 600-840 bar, pre-filled is filled with a high quality lubricant, NLGI class 2.
The high pressure hose 600-840 bar plays a fundamental role in various applications, both in the automotive industry but also in all other industries, wherever maintenance is automated with means of a central lubrication system.
Of course, the high pressure hose 600-840 bar may also be used as a manual lubrication tool with our nipple block.
The typical application of the high pressure hose 600-840 bar is the use as main line in a central lubrication system. Basically, the main line is the path from the piston pump to the main distributer. This is a progressive distributor in the form of a block distributor or as a disc distributor, also called segment distributor.
The high pressure hose 600-840 bar is also used as a secondary line between the main distributor to the downstream secondary distributor, also called sub-distributor.
Because of its extreme flexibility and the tremendously durable surface, the high pressure hose is also used in many other ways as a lubricating hose or grease pipe in automatic or manual lubrication systems.
In all areas of central lubrication technology, the high pressure hose 600-840 bar proves itself as very reliable and efficient with its surprisingly low inside and outside diameter and very small bending radii.
In practice, this type of high pressure hose 840 bar is mainly used where the hoses are subject to high pressures and permanent, continuous movements and yet need to ensure a high level of safety. Furthermore, the high pressure hose 840 bar is also suited for the installation into static equipment and devices, while the flexibility aspect is not as crucial as with dynamic components. Both static and dynamic conditions are found everywhere in the sector of central lubrication technology.
The high pressure hose 600-840 bar is equipped with the screw sleeve (threaded sleeve) and a hose stud (pipe fitting) at its respective line ends and thus ready for connection. For the installation of the screw sleeve and the hose stud, the mechanic will require no special tools. The screw sleeve and the hose stud can be installed wherever the line end of the high pressure hose 600-840 bar is located by using common ring spanners. This is of particular importance for the installation of a central lubrication system.
Category: Products - fittings - high pressure hose